Well, Travis made the drive over from MN on Saturday, and we managed to get all the lights and wiring dialed in. Then I finished running all the cables and got the bars taped today. It's ready for the show!
I'll just give you a tour of a couple of the highlights! To see it up close, stop by my booth at NAHBS this weekend!
I used the Schmidt SONdelux front hub, it has the contact built into the front drive side dropout, so no plugs to worry about, just install the wheel correctly and your generator is ready to go. The dropouts are stainless plate, so I finished them with slightly raised points and Jason masked the whole dropout.
The custom front rack with internal wire routing and Edelux front light, super bright!
We made all the wiring connections and then slid them up inside the steerer tube. All that's visible is a small wire heading into the frame for the taillight.
That's all for now, I'll see you in Austin!